How do I resume a task?

Whirl enables you to resume the previously stopped task.

Note: If you start a new task, you cannot resume the previous task because starting a new task discards all data for the previous task. Also, if you never started a task (first time user), the Resume Task button is disabled because there was no task for you stop then resume.

To resume a task:

1. Drive toward the location in your field where you stopped the task.
   
   
2. On the Wheelman screen tap RESUME TASK.
   
   
   The map screen appears with: a dotted line showing the distance and path to your last apply point (Last Position) where you turned APPLY off in Whirl, your current heading (333°), and your crosstrack (167 inches to the right of the wayline).
   
   
   
3. Tap ENGAGE AUTOSTEERING to engage on the wayline then tap APPLY ON when you reach the point where you want to begin recording (product application or area covered) again. The example below shows you are four yards from your last apply point while engaged on the wayline (but you have yet to turn Apply on).