How do I add an implement?
NOTE: See also the Wheelman Quick Start Guide for instructions on adding an implement upon initial login.
Whirl app only: You add an implement only after setting up and calibrating the vehicle.
To add an implement:
- When you complete vehicle calibration you are returned to the task screen with the Implement field enabled (the Implement field is disabled until you complete calibration).
Each time you start Whirl, if you have already set up your vehicle and connected to Wheelman via Wi-Fi, the task screen appears. Additionally, stopping a task takes you to the task screen. - Tap Implement, then:
- iOS: Tap Add Implement, type a name and width for the implement (see below), then tap Save.
- Android: Tap
at the lower right of the screen, type a name and tap NEXT, then type the width and tap ADD.
- iOS: Tap Add Implement, type a name and width for the implement (see below), then tap Save.
Note: For implement width, the (in) is not required (for example, if the width is 32 ft, you do not need to enter zero for the inches).
When finished, the implement is added to the list of implements. To use the new implement, tap it.
That implement will then appear on the task screen (Tiller example shown below).